CCWorks

Making dreams, reality. One bike at a time

Frame part 8!

Page 9

           Before you can do the engine mounts you have to make sure the chunk lines up with the yoke on the engine. If it doesn't then you will have undue wear on the shaft and seal.

Here are the rear head mounts. I put these in first to help stabilize and true up the engine.

Here are the rear mounts. All mounts are made from 1/4 inch flat-bar. The nuts will be welded to the mount so the customer wont have to fool with loosing them if he ever removes the engine

I chose to use the factory front mount plate for ease of motor instillation and less fabrication.